Arduino - MiniBootloader

Arduino - MiniBootloader:


How do I make the cable?

You need to connect 6 pins on the Arduino Mini to six pins on the ISP. The six pins are called MISO, MOSI, SCK, RESET, Power and Ground. Three of them correspond to digital I/O pins, numbered 11 - 13. The other three are the Reset, +5V and Ground pins you have probably already been using. (Note that you want to use the +5V pin, not the +9V pin. This is used to supply power to the ISP.)

These pins on the Arduino have to be connected to the corresponding pins on the 6-pin connector coming from the ISP, shown below.

댓글

이 블로그의 인기 게시물

4,5,6 띠 저항의 색띠를 읽는 법(띠저항 값)

remove bluebirds.exe , virtual drive

수지에서 인천공항 리무진 버스 (인천공항버스정보)(2022년3월업데이트)